Ford Mondeo since 2000
1. Introduction
2. Equipment
3. Care of the car
4. Engines
4.1. To make in a workshop or it is independent
4.2. Проворачивание the engine
4.3. Compression degree
4.4. Measurement of degree of compression
4.5. Check приводных belts
4.6. Installation приводных belts
4.7. Definition of a place of malfunction by listening – noise in a motor compartment
5. Greasing system
6. Cooling system
7. System of injection of fuel
8. Ignition system
9. Fuel system
10. Transmission
11. A running gear
12. Brake system
13. The electrotechnical equipment
14. Electroschemes
15. Car salon
16. A body
17. Technical characteristics
18. The help at malfunctions
 



ba88fb63





4-6-montazh-privodnykh-remnejj.html

4.6. Installation приводных belts

 PERFORMANCE ORDER

    Release tightening screws on tension скобе. Unscrew screws on a rotary support and «ослабьте» it. Replace an old belt with the new. Instal upside-down.

 PRACTICAL ADVICE

Installation приводного a belt

Never "press" new приводной a belt by means of a screw-driver into belt pulleys. At the expense of occurrence of places of crisis in a lining of a belt you thereby already program again soon the following unforeseen replacement. After installation of already used belt start the engine approximately for 3 minutes and then again check up a belt tension. Before an engine stop some times accelerate motor work quickly on average turns. After 1000 kilometres of run again check up a belt tension (3–5 millimetres).


«The previous page
4.5. Check приводных belts
The following page»
4.7. Definition of a place of malfunction by listening – noise in a motor compartment