> Replacement of draught of a pedal of gas (on example Duratec-HE). Ford Mondeo (since 2000 of release)
Ford Mondeo since 2000
1. Introduction
2. Equipment
3. Care of the car
4. Engines
5. Greasing system
6. Cooling system
7. System of injection of fuel
7.1. It is sometimes rational to spend visual survey of system of injection
7.2. Check of inlet system on tightness
7.3. Check of frequency of rotation at idling
7.4. Fluctuations at idling – the regular phenomenon
7.5. Check of the adjusting valve of system of idling
7.6. Atomizer check
7.7. Replacement of draught of a pedal of gas (on example Duratec-HE)
7.8. Топливоснабжение the diesel engine – a base design
7.9. Visual check of system of injection of the diesel engine
7.10. Replacement of a filtering cartridge
8. Ignition system
9. Fuel system
10. Transmission
11. A running gear
12. Brake system
13. The electrotechnical equipment
14. Electroschemes
15. Car salon
16. A body
17. Technical characteristics
18. The help at malfunctions
 






ba88fb63

7-7-zamena-tyagi-pedali-gaza-na-primere-duratec-he.html

7.7. Replacement of draught of a pedal of gas (on example Duratec-HE)

 PERFORMANCE ORDER

  1. Dismantle an inlet hose between the air filter and the engine. For this purpose release two collars (are specified by arrows) and remove a hose.

    Dismantle of an inlet hose.

  2. Dismantle now pipelines and hoses from the top facing of the engine, release connections and.
  3. ... Disconnect engine facing.
  4. Now lower draught of a pedal of gas on the case throttle заслонки (it is specified by an arrow).

    Posting of draught of a pedal of gas on the case throttle заслонки.

  5. Dismantle a covering in space for feet.
  6. Dismantle draught from an accelerator pedal.
  7. For simplification of installation of new draught "connect" both draughts in a motor compartment and drag old draught new draught on the place.
  8. Finish installation of new draught upside-down.

     Attention: before passing new draught through a rubber nozzle in a forward wall, fix a nozzle and before installation grease slightly "rubber" with vaseline.


The previous page
7.6. Atomizer check
The following page
7.8. Топливоснабжение the diesel engine – a base design