> Replacement of hoses of a cooling liquid. Ford Mondeo (since 2000 of release)
Ford Mondeo since 2000
1. Introduction
2. Equipment
3. Care of the car
4. Engines
5. Greasing system
6. Cooling system
6.1. A cooling liquid
6.2. Check of system of cooling on tightness
6.3. Check and доливка a cooling liquid
6.4. Replacement of a cooling liquid
6.5. Addition of a protection frame from замерзаниядо–30 C
6.6. Dismantle and thermostat check – only at the cooled engine
6.7. First aid – перемкнуть a thermoswitch
6.8. Dismantle of the fan of system of cooling
6.9. Dismantle and radiator installation
6.10. Replacement of hoses of a cooling liquid
6.11. The air filter (the muffler of noise of an admission)
6.12. Clearing and replacement of a filtering cartridge
7. System of injection of fuel
8. Ignition system
9. Fuel system
10. Transmission
11. A running gear
12. Brake system
13. The electrotechnical equipment
14. Electroschemes
15. Car salon
16. A body
17. Technical characteristics
18. The help at malfunctions
 






ba88fb63

6-10-zamena-shlangov-okhlazhdayushhejj-zhidkosti.html

6.10. Replacement of hoses of a cooling liquid

If during movement Mondeo at you the hose of a cooling liquid was broke off, condense in the beginning a place of a leaking with temporarily gluing tape. For safety slightly unscrew запорную a cover of a broad tank: working pressure thus is not generated, so the place of a patch a tape can "hold on" before definitive repair. During movement constantly pay attention to the indicator of temperature of the engine and at all do not lead up it to limiting value. As spare details get only original hoses as they гарантированно approach and do not harden at once through short time. Fixing collars of hoses should be attentively seen – коррозированные collars immediately replace.

 PERFORMANCE ORDER

  1. Merge cooling liquid in the established pure capacity.
  2. Release шланговые collars, disconnect hoses.
  3. Strongly sitting ends of a hose ослабьте by means of a screw-driver. For this purpose insert the tool between a hose and a branch pipe and cautiously wring out from a corresponding connecting branch pipe.
  4. Grease new hoses with vaseline and properly spread on a branch pipe that they during driving could not slip.

    Operate resolutely: Tightening скобы 1 and 2 on water and fuel hoses. If you replace old hoses of a radiator or fuel hoses or have removed serial tightening скобы for installation of new hoses it is possible to use carving скобы 3. Carving скобы squeeze hoses on большей surfaces, besides, it is possible to appoint is better their degree зажатия.


The previous page
6.9. Dismantle and radiator installation
The following page
6.11. The air filter (the muffler of noise of an admission)