Ford Mondeo since 2000
1. Introduction
2. Equipment
3. Care of the car
4. Engines
5. Greasing system
6. Cooling system
7. System of injection of fuel
8. Ignition system
8.1. The ignition coil
8.2. Proof to a heat – spark plugs
8.3. Replacement of spark plugs – after 60 000 kilometres
8.4. Check by means of the universal device – the gauge of frequency of rotation
8.5. By means of the assistant to any problems – check of the gauge of pressure
8.6. Harmonious work – current check in системезажигания
8.7. It is carried out by means of the universal device – resistance measurement on the ignition coil
8.8. Dismantle of the block of ignition
8.9. Heating of the cold diesel engine – the device of a preliminary warming up
8.10. Check of the device of a preliminary warming up
8.11. Check of the relay of a preliminary warming up
8.12. Check of candles накаливания
9. Fuel system
10. Transmission
11. A running gear
12. Brake system
13. The electrotechnical equipment
14. Electroschemes
15. Car salon
16. A body
17. Technical characteristics
18. The help at malfunctions
 



ba88fb63



8-5-s-pomoshhyu-pomoshhnika-nikakikh-problem-proverka-datchika-davleniya.html

8.5. By means of the assistant to any problems – check of the gauge of pressure

 PERFORMANCE ORDER

    Disconnect a hose from the gauge of pressure and close an aperture a tip of the finger. Let your assistant will start the engine and will finish it to average turns (about 2000 rpm). Again connect a hose to the gauge at constant number of turns. As the lowered pressure adjustment of the moment of ignition of the block of management should work is again put to the gauge. At the same position of a pedal of gas the engine rotates much more strongly. However if frequency of rotation remains to a constant, it means that a hose of the lowered pressure негерметичен or the defective gauge of pressure. The engine marks this fact fall of capacity and in bad parametres of the fulfilled gas.

«The previous page
8.4. Check by means of the universal device – the gauge of frequency of rotation
The following page»
8.6. Harmonious work – current check in системезажигания