Ford Mondeo since 2000
1. Introduction
2. Equipment
3. Care of the car
4. Engines
5. Greasing system
6. Cooling system
7. System of injection of fuel
8. Ignition system
9. Fuel system
10. Transmission
10.1. Coupling
10.2. Coupling check
10.3. Whether coupling is completely separated?
10.4. A five-step mechanical transmission
10.5. Gear change adjustment
10.6. Level check трансмиссионного oils (a mechanical transmission)
10.7. Good alternative to a mechanical transmission – automatic box Mondeo in a combination with 2,0-litre engine Duratec-HE
10.8. Level check трансмиссионного oils (an automatic transmission)
10.9. The main transfer
10.10. Check of cuffs of power shafts
10.11. Dismantle and power shaft installation / the cross-section lever of a suspension bracket
10.12. Replacement of cuffs карданного the hinge
11. A running gear
12. Brake system
13. The electrotechnical equipment
14. Electroschemes
15. Car salon
16. A body
17. Technical characteristics
18. The help at malfunctions
 



ba88fb63




10-10-proverka-manzhet-privodnykh-valov.html

10.10. Check of cuffs of power shafts

 PERFORMANCE ORDER

    Put on goats a forward part of the car with freely hanging wheels. Turn a steering wheel against the stop to the left and to the right. External in relation to a bend a wheel rotate a hand and thus check an external cuff on presence of small cracks and fragile places. If in hinges the dirt or dampness, hinge write-off in scrap metal – already only a matter of time has stood. For check of internal cuffs it is necessary to lay down under forward wheels and to ask the assistant to rotate slowly wheels. Check up landing of clamping collars. Damp traces on cuffs are absolutely exact harbingers: as soon as possible establish the reason and a source. Otherwise the hinge long "will not live". Internal hinges are filled at factory 125 г special greasing. New pouring of external hinges makes 100 г, at replacement of a cuff it is enough 60 г greasing MoS2. Ford uses specifications SM-1C75-A or SQN-1C9004-A.

    During carrying out of check of protective cuffs of power shafts it is necessary to check also strong landing of external 1 and coupling collars 2. By means of lateral обрезателя tape clips of a hole tape (are specified by an arrow) are tightened. For this purpose a ledge in the form of flattened out "About" bend to a tightening tape and by means of lateral обрезателя with feeling so clamp not to crush a cuff. The power shaft should be pure in a place of landing of a cuff.

«The previous page
10.9. The main transfer		 The following page»
10.11. Dismantle and power shaft installation / the cross-section lever of a suspension bracket