Ford Mondeo since 2000
1. Introduction
2. Equipment
3. Care of the car
4. Engines
5. Greasing system
6. Cooling system
7. System of injection of fuel
8. Ignition system
9. Fuel system
10. Transmission
11. A running gear
12. Brake system
13. The electrotechnical equipment
14. Electroschemes
15. Car salon
16. A body
16.1. Dismantle and door installation
16.2. Door adjustment
16.3. Dismantle and installation of an external rear-view mirror
16.4. Dismantle and installation обтекателя
16.5. Dismantle and cowl installation
16.6. Adjustment of a cowl of the engine
16.7. Dismantle and installation of a cover of a bumper (forward)
16.8. Dismantle and installation of wings
16.9. Dismantle and installation of a cover of a bumper (back)
16.10. Dismantle and installation of a cover of a luggage carrier
16.11. Adjustment of a cover of a luggage carrier
16.12. Dismantle and installation of the lock of a back door
17. Technical characteristics
18. The help at malfunctions
 



ba88fb63





16-10-demontazh-i-montazh-kryshki-bagazhnika.html

16.10. Dismantle and installation of a cover of a luggage carrier

This work in all models is approximately identical. The operations procedure for model with a body a sedan is more low considered.

 PERFORMANCE ORDER

    Put the Mondeo on an equal surface, disconnect the storage battery and open a luggage carrier cover. Dismantle the lock of a cover and disconnect a socket of system of locks of doors with the central management. Dismantle an internal covering of a cover (11 fixing clips) and on the free end of a socket fix a cord piece. Remove a rubber tip in an aperture from above a lateral wall and pull out then a wire from a cover. Mark with a felt-tip pen position of loops on a luggage carrier cover. Ask the assistant to take a luggage carrier cover, at this time on both parties unscrew loopy screws (are specified by arrows).

    Unscrew four loopy screws (are specified by arrows) on a luggage carrier cover.

    Uncover and put so that it could not overturn. Instal upside-down. If the former cover cannot be mounted repeatedly before installation complete a new element from "interiors" of an unnecessary cover. Preliminary slightly fix a cover and then adjust its position according to available marks. In the beginning level a new cover approximately.

«The previous page
16.9. Dismantle and installation of a cover of a bumper (back)
The following page»
16.11. Adjustment of a cover of a luggage carrier