Ford Mondeo since 2000
1. Introduction
2. Equipment
3. Care of the car
4. Engines
5. Greasing system
6. Cooling system
7. System of injection of fuel
8. Ignition system
9. Fuel system
10. Transmission
11. A running gear
12. Brake system
13. The electrotechnical equipment
14. Electroschemes
15. Car salon
16. A body
16.1. Dismantle and door installation
16.2. Door adjustment
16.3. Dismantle and installation of an external rear-view mirror
16.4. Dismantle and installation обтекателя
16.5. Dismantle and cowl installation
16.6. Adjustment of a cowl of the engine
16.7. Dismantle and installation of a cover of a bumper (forward)
16.8. Dismantle and installation of wings
16.9. Dismantle and installation of a cover of a bumper (back)
16.10. Dismantle and installation of a cover of a luggage carrier
16.11. Adjustment of a cover of a luggage carrier
16.12. Dismantle and installation of the lock of a back door
17. Technical characteristics
18. The help at malfunctions
 



ba88fb63 Hydra как зайти с телефона читать дальше.



16-7-demontazh-i-montazh-kryshki-bampera-perednego.html

16.7. Dismantle and installation of a cover of a bumper (forward)

 PERFORMANCE ORDER

    Lift on an emphasis and fix a forward part of the car and dismantle a radiator lattice (fastening places are specified by arrows).

    Dismantle of a lattice of a radiator.

    If you Mondeo has system of washing of headlights dismantle facings snuffled. Dismantle further the bottom protective lattice (screws are specified by arrows).

    Unscrew eleven screws and remove the bottom protective lattice.

    Disconnect the tip of an alarm lamp of temperature of external air and an antifog headlight (if it is mounted). Unscrew in both wheel niches a cover of a bumper from protection разбрызгивания (places are specified by arrows) and then …

    Unscrew a cover of the buffer from protection разбрызгивания.

    … in both niches dismantle a cover of a bumper from wings (screws are specified by arrows).

    Unscrew a cover of a bumper from both wings.

    After you unscrew all screws, separate a cover from the buffer moving forward. Instal upside-down. It is natural before definitively fixing a cover on wings, level it on height and sides.

«The previous page
16.6. Adjustment of a cowl of the engine
The following page»
16.8. Dismantle and installation of wings