> Dismantle and cowl installation. Ford Mondeo (since 2000 of release)
Ford Mondeo since 2000
1. Introduction
2. Equipment
3. Care of the car
4. Engines
5. Greasing system
6. Cooling system
7. System of injection of fuel
8. Ignition system
9. Fuel system
10. Transmission
11. A running gear
12. Brake system
13. The electrotechnical equipment
14. Electroschemes
15. Car salon
16. A body
16.1. Dismantle and door installation
16.2. Door adjustment
16.3. Dismantle and installation of an external rear-view mirror
16.4. Dismantle and installation обтекателя
16.5. Dismantle and cowl installation
16.6. Adjustment of a cowl of the engine
16.7. Dismantle and installation of a cover of a bumper (forward)
16.8. Dismantle and installation of wings
16.9. Dismantle and installation of a cover of a bumper (back)
16.10. Dismantle and installation of a cover of a luggage carrier
16.11. Adjustment of a cover of a luggage carrier
16.12. Dismantle and installation of the lock of a back door
17. Technical characteristics
18. The help at malfunctions
 






ba88fb63

16-5-demontazh-i-montazh-kapota.html

16.5. Dismantle and cowl installation

Both half of loop are screwed on a cowl of the engine and a wheel niche. New Mondeo has preliminary intense loops which in the closed condition possess certain preliminary pressure. Advantage: arising backlashes of loops are compensated, and, besides, at a counter air stream the cowl lies "more easy".

 PERFORMANCE ORDER

  1. Open a cowl of the engine and prop up it.
  2. For simplification of installation mark from both parties position of loops on a cowl.

    Mark from both parties position of hinges on a cowl.

  3. Release hoses стеклоомывателя from fastening and cautiously pull out from the corresponding snuffled. The hardened places of hoses in the beginning slightly warm up a lighter.
  4. Unscrew loopy screws on a cowl, and also a regulator of a cowl and together with the assistant remove then a cowl.

    Are preliminary strained: hinges of a cowl of the engine.

    1 — the Fixing flange on a cowl,
    2 — Contact surfaces,
    3 — the Half of the hinge of a course of a wheel.

  5. Before installation complete a new cowl with "old" details.
  6. For installation together with the assistant put a cowl and level according to marks. Then tighten loopy bolts.

The previous page
16.4. Dismantle and installation обтекателя
The following page
16.6. Adjustment of a cowl of the engine