Ford Mondeo since 2000
1. Introduction
2. Equipment
3. Care of the car
4. Engines
5. Greasing system
6. Cooling system
7. System of injection of fuel
8. Ignition system
9. Fuel system
10. Transmission
11. A running gear
12. Brake system
13. The electrotechnical equipment
14. Electroschemes
15. Car salon
16. A body
16.1. Dismantle and door installation
16.2. Door adjustment
16.3. Dismantle and installation of an external rear-view mirror
16.4. Dismantle and installation обтекателя
16.5. Dismantle and cowl installation
16.6. Adjustment of a cowl of the engine
16.7. Dismantle and installation of a cover of a bumper (forward)
16.8. Dismantle and installation of wings
16.9. Dismantle and installation of a cover of a bumper (back)
16.10. Dismantle and installation of a cover of a luggage carrier
16.11. Adjustment of a cover of a luggage carrier
16.12. Dismantle and installation of the lock of a back door
17. Technical characteristics
18. The help at malfunctions
 



ba88fb63





16-6-regulirovka-kapota-dvigatelya.html

16.6. Adjustment of a cowl of the engine

 PERFORMANCE ORDER

    Work with preliminary mounted cowl strictly point behind point according to the order resulted more low – otherwise preliminary intense hinges can «arrange to you dance». Level in regular intervals a cowl between обтекателем and two wings (base position). Tighten at an open cowl only back fastening of loops 2. Forward fastening 1 not to touch yet.

    Tighten back fastening of hinges 2. 1 — Forward fastening.

    Will expose further forward fastening 1 completely upwards and slightly tighten the screw. The word "slightly" here means that when the cowl is closed, the loop gives in a little more. Now give the chance to a cowl «to fall slightly» to cowl protection. The forward edge of a cowl should be in this position approximately on 10 millimetres over a wing ().

    Position of a forward edge of a cowl () = 10 millimetres.

    Open a cowl and tighten the forward loopy screw. If necessary, after the cowl has been completely closed, once again modify preliminary pressure.

 PRACTICAL ADVICE

The zapornyj cylinder of a cowl of the engine – emblem Ford

The engine cowl in new Mondeo does not open now any more a tension of a cable from salon, and outside by means of the ignition key. The zapornyj cylinder is behind emblem Ford in a radiator lattice – the firm badge serves simultaneously and as a guard from dirt hit. If you not up to the end close an emblem an aperture for a key being behind it запорный the cylinder becomes "defenceless" against a road dirt. Already through some kilometres in запорный the mechanism gets into a cold season road salt and blocks the cylinder. If it happens, it is necessary to wash out quickly запорный the cylinder spirit or kerosene and then again to "recover" its interiors in pair drops of the silicone sprayed oil.

In due course, however, the lock spring of an emblem can a little ослабнуть. Therefore from time to time check correct landing – and especially after moved on a bumpy line or if washing brushes of washing installation have finished yours Mondeo to shine.

To open a cowl, turn an emblem aside, turn the ignition key to the left and simultaneously raise a cowl a little. Turn then the ignition key to the right and open a cowl.


«The previous page
16.5. Dismantle and cowl installation
The following page»
16.7. Dismantle and installation of a cover of a bumper (forward)