> Dismantle and installation of the fuel pump (the petrol engine). Ford Mondeo (since 2000 of release)
Ford Mondeo since 2000
1. Introduction
2. Equipment
3. Care of the car
4. Engines
5. Greasing system
6. Cooling system
7. System of injection of fuel
8. Ignition system
9. Fuel system
9.1. Fuel
9.2. Check of ventilation and tank airing
9.3. Replacement of the fuel filter (the petrol engine)
9.4. Replacement of the fuel filter (the diesel engine)
9.5. Опорожнение a tank – patient game without the fuel pump, demanding sleight of hand
9.6. Dismantle of pipelines and hoses (the general instructions)
9.7. Search of malfunctions of the fuel pump
9.8. Dismantle and installation of the fuel pump (the petrol engine)
9.9. System of release of the fulfilled gases
9.10. Councils for work with an exhaust system
9.11. A cost question – a complete repair or partial replacement
9.12. The poorly fulfilled gas - ASU
9.13. Neutralisation of the fulfilled gases
10. Transmission
11. A running gear
12. Brake system
13. The electrotechnical equipment
14. Electroschemes
15. Car salon
16. A body
17. Technical characteristics
18. The help at malfunctions
 






ba88fb63

9-8-demontazh-i-montazh-toplivnogo-nasosa-benzinovyjj-dvigatel.html

9.8. Dismantle and installation of the fuel pump (the petrol engine)

 PERFORMANCE ORDER

  1. Disconnect a wire on weight of the storage battery.
  2. Empty a fuel tank and dismantle it under the car.
  3. Dismantle submitting and drain pipelines, and also a connecting wire.
  4. Cautiously release a fixing ring the special tool (Ford 23055) or by means of a punch and a hammer and turn out.
  5. To pull out the pump from a tank, turn slightly the case counter-clockwise.
  6. For installation of the new pump use a new sealing ring.
  7. In the beginning clean all condensing surfaces and necessarily level all assembly marks on a tank and the fuel pump against each other.
  8. Tighten a safety ring with the moment of an inhaling 80 Нм and finish installation upside-down.
  9. Again connect the accumulator, let the pump will work within nearby 30 seconds at the included ignition. So much time will be enough that pressure of fuel in system was established in norm.
  10. In end check up all connections of pipelines on tightness.

The previous page
9.7. Search of malfunctions of the fuel pump
The following page
9.9. System of release of the fulfilled gases