Ford Mondeo since 2000
1. Introduction
2. Equipment
3. Care of the car
4. Engines
5. Greasing system
6. Cooling system
7. System of injection of fuel
8. Ignition system
9. Fuel system
10. Transmission
11. A running gear
12. Brake system
13. The electrotechnical equipment
14. Electroschemes
15. Car salon
16. A body
17. Technical characteristics
18. The help at malfunctions
18.1. A starter
18.2. The accumulator and the generator
18.3. System of injection of gasoline
18.4. Brakes
18.5. Injection system - a diesel engine
18.6. Electric стеклоподъемник
18.7. A heating system
18.8. Cooling system
18.9. Coupling
18.10. The engine and system
18.11. Braking signals
18.12. A screen wiper
18.13. Greasing system
18.14. The thermostat
18.15. System of the sound and light alarm system
18.16. Screen wiper brushes
18.17. System of locks with the central management
18.18. Spark plugs
18.19. A lining of a head of the block of cylinders
 



ba88fb63



18-16-shhetki-stekloochistitelya.html

18.16. Screen wiper brushes

The reason
Elimination
A.Voda and a dirt are in regular intervals distributed on clearing sector.
    Glass is polluted by means for care of varnishing, маслосодержащими the rests or the rests инкрементов. Screen wiper rubber is worn out. In a place шарнирного connections will turn the screen wiper lever and is not parallel to glass.
    Put on glass "Sidol" or other cleaner, allow to dry out and wipe a pure rag. Replace. Bend the end of the lever of a screen wiper (slightly braid).
. In clearing sector there are thin strips of water.
Look А2. Replace.
Century In clearing sector remain some water strips.
Angle of slope of a rubber tape of a screen wiper too sharp in relation to glass. Replace a rubber tape.
In clearing sector there are thin drops of water.

Non-uniform clamping effort – the bent or defective press spring in a rubber tape of a screen wiper.

 Replace a screen wiper brush.
Д. In clearing sector there is a water film.
    The clamping effort of the lever of a screen wiper is not enough. The screen wiper drive is worn out. The screen wiper lever in the axis is free. The screen wiper lever is bent. The screen wiper brush is bent.
    Check up clamping effort. Slightly grease a spring, pull the lever of a screen wiper more strongly or replace. Check up, defective details replace. Fix. Bend. Replace.
Е. In the top sector of clearing there are water zones.
    Look Д1. Look
Z.ShChetka crackles.
    The big backlash in system of draughts of a screen wiper. The screen wiper lever is free. The screen wiper lever is turned.
    Replace the worn out details. Fix. Dismantle a brush of a screen wiper and level the lever.

The previous page
18.15. System of the sound and light alarm system
The following page
18.17. System of locks with the central management