Ford Mondeo since 2000
1. Introduction
2. Equipment
3. Care of the car
4. Engines
5. Greasing system
6. Cooling system
7. System of injection of fuel
8. Ignition system
9. Fuel system
10. Transmission
11. A running gear
12. Brake system
12.1. Check of level of a brake liquid
12.2. Check of brake system
12.3. Check of the amplifier of a brake drive
12.4. Check of brakes on functioning
12.5. Deterioration measurement колодок the disk brake mechanism
12.6. Check износадискового the brake mechanism
12.7. Prorolling of brake system
12.8. Replacement of a brake liquid
12.9. Dismantle of a compensatory tank of the main brake cylinder
12.10. Dismantle and installation of the main brake cylinder
12.11. Dismantle and installation of the amplifier of a brake drive
12.12. Dismantle and installation of brake hoses
12.13. Replacement колодок the disk brake mechanism
12.14. Replacement of disks of the brake mechanism
12.15. To make suitable a support and the piston of the brake mechanism – replacement of protective cuffs
12.16. A lay brake
12.17. Replacement of a cable of a lay brake
13. The electrotechnical equipment
14. Electroschemes
15. Car salon
16. A body
17. Technical characteristics
18. The help at malfunctions
 



ba88fb63





12-12-demontazh-i-montazh-tormoznykh-shlangov.html

12.12. Dismantle and installation of brake hoses

 PERFORMANCE ORDER

    In the beginning turn on накидную a nut of the brake pipeline, then release other party of a hose. Track that the pipeline was not braided. The majority of brake hoses are protected from slipping by the holder of a sleeve (metal скоба). At installation do not forget about it. At installation tighten in the beginning the external carving party, then накидную a nut. Never mount a hose in the braided condition. Correct landing can be distinguished on colour strips passing along a hose, rubber литникам or to a rubber profile. After installation pump over brake system as it is described above. Necessarily check up, whether has a new hose at spring moving appropriate freedom of a course. If is not present, displace the remote holder. Check up course freedom once again after a long trip.

    If brake pipelines 2 and brake hoses 4 are connected to the metal holder 3 in the elastic holder of a hose 1 there is no necessity. For a detachment of such connection the key for brake hoses 5 which completely covers a pipeline nut is used.

    Requires freedom (it is specified by an arrow) at amortisation: a brake hose.


«The previous page
12.11. Dismantle and installation of the amplifier of a brake drive
The following page»
12.13. Replacement колодок the disk brake mechanism