> Dismantle of a compensatory tank of the main brake cylinder. Ford Mondeo (since 2000 of release)
Ford Mondeo since 2000
1. Introduction
2. Equipment
3. Care of the car
4. Engines
5. Greasing system
6. Cooling system
7. System of injection of fuel
8. Ignition system
9. Fuel system
10. Transmission
11. A running gear
12. Brake system
12.1. Check of level of a brake liquid
12.2. Check of brake system
12.3. Check of the amplifier of a brake drive
12.4. Check of brakes on functioning
12.5. Deterioration measurement колодок the disk brake mechanism
12.6. Check износадискового the brake mechanism
12.7. Prorolling of brake system
12.8. Replacement of a brake liquid
12.9. Dismantle of a compensatory tank of the main brake cylinder
12.10. Dismantle and installation of the main brake cylinder
12.11. Dismantle and installation of the amplifier of a brake drive
12.12. Dismantle and installation of brake hoses
12.13. Replacement колодок the disk brake mechanism
12.14. Replacement of disks of the brake mechanism
12.15. To make suitable a support and the piston of the brake mechanism – replacement of protective cuffs
12.16. A lay brake
12.17. Replacement of a cable of a lay brake
13. The electrotechnical equipment
14. Electroschemes
15. Car salon
16. A body
17. Technical characteristics
18. The help at malfunctions
 






ba88fb63

12-9-demontazh-kompensacionnogo-bachka-glavnogo-tormoznogo-cilindra.html

12.9. Dismantle of a compensatory tank of the main brake cylinder

 PERFORMANCE ORDER

  1. Disconnect the main socket of the gauge of level of a liquid and...
  2. ... Also unscrew запорную a cover from a tank. After its removal do not overturn it. It can damage electric contacts.
  3. Suck away a brake liquid from a compensatory tank by means of a pipette or a syringe.
  4. Cautiously remove hands an empty tank from the main brake cylinder.
  5. Before mounting a new tank, insert new sealing rings into apertures of the main brake cylinder. Preliminary slightly humidify these rings with a fresh brake liquid.
  6. Accurately press a new tank into sealing rings. The tank should is heard to be fixed. Further fill in a liquid.
  7. Twirl запорную a cover and check up functioning of the switch of the precautionary light alarm system – for this purpose press the elastic middle of a cover.
  8. Pump over brake system.

    Teamwork: in a tandem with the main brake cylinder two brake pistons work.

    1 — the Pusher of a brake contour,
    2 — "the Floating" basic brake contour,
    3 — Primary cuffs,
    4 — Separate cuffs.


The previous page
12.8. Replacement of a brake liquid
The following page
12.10. Dismantle and installation of the main brake cylinder