Ford Mondeo since 2000
1. Introduction
2. Equipment
3. Care of the car
4. Engines
5. Greasing system
6. Cooling system
7. System of injection of fuel
8. Ignition system
9. Fuel system
10. Transmission
11. A running gear
12. Brake system
12.1. Check of level of a brake liquid
12.2. Check of brake system
12.3. Check of the amplifier of a brake drive
12.4. Check of brakes on functioning
12.5. Deterioration measurement колодок the disk brake mechanism
12.6. Check износадискового the brake mechanism
12.7. Prorolling of brake system
12.8. Replacement of a brake liquid
12.9. Dismantle of a compensatory tank of the main brake cylinder
12.10. Dismantle and installation of the main brake cylinder
12.11. Dismantle and installation of the amplifier of a brake drive
12.12. Dismantle and installation of brake hoses
12.13. Replacement колодок the disk brake mechanism
12.14. Replacement of disks of the brake mechanism
12.15. To make suitable a support and the piston of the brake mechanism – replacement of protective cuffs
12.16. A lay brake
12.17. Replacement of a cable of a lay brake
13. The electrotechnical equipment
14. Electroschemes
15. Car salon
16. A body
17. Technical characteristics
18. The help at malfunctions
 



ba88fb63





12-4-proverka-tormozov-na-funkcionirovanie.html

12.4. Check of brakes on functioning

Check of brakes is spent on road only in the event that with it do not interfere or other participants of traffic are not endangered. For such check find equal, whenever possible remote site of road with a good covering. In cars with АБС in the beginning it is necessary to disconnect it.

 PERFORMANCE ORDER

    At first move in slow rate, press coupling and then brake at the full capacity. Compare now brake traces on road – traces of identical length specify in in regular intervals operating brakes. Spend then similar "exercise" with a lay brake. At the second stage accelerate the car to 50 km/hour – do not compress convulsively a steering wheel and do not correct in the course of braking a movement direction. Then brake in the beginning softly, and then it is sharp to a full stop. The car should to remain confidently on a straight line. Otherwise brakes "pull" in one party. In any case find a workshop in which there is a test bed for check of brake system. For check of work of knots of brake system at the third stage in an idle time mode it is necessary on slightly sloping site of road for yours Mondeo simply to slide downwards from «a rest condition». If it slides "poorly", all wheels are free also a backlash between brake segments and disks of brake drives is perfectly in order. After a short trial trip check up temperature of disks: for this purpose take a hand in their stars – all wheels should be equally warm.

«The previous page
12.3. Check of the amplifier of a brake drive
The following page»
12.5. Deterioration measurement колодок the disk brake mechanism