Ford Mondeo since 2000
1. Introduction
2. Equipment
3. Care of the car
4. Engines
5. Greasing system
6. Cooling system
7. System of injection of fuel
8. Ignition system
9. Fuel system
10. Transmission
11. A running gear
12. Brake system
13. The electrotechnical equipment
13.1. The storage battery and a starter
13.2. The generator
13.3. Check of level of electrolit in the accumulator
13.4. Care of contacts
13.5. Check of the storage battery
13.6. Engine start "from outside" – with a wire connecting a starter and the auxiliary storage battery, without problems
13.7. Car pushing
13.8. Car towage
13.9. Gymnastics of the storage battery
13.10. Replacement of the storage battery
13.11. Revealing of secret consumers of the electric power
13.12. Check of a regulator of pressure
13.13. Replacement приводных belts
13.14. Replacement of a belt clamping roller
13.15. Dismantle and generator installation
13.16. Starter replacement
13.17. External illumination
13.18. Any big problems – replacement of lamps накаливания
13.19. A provisional measure – adjustment of headlights «before a wall»
13.20. Signalling devices
13.21. Check of the switch of a signal of braking
13.22. Check of a sound signal
13.23. Tools and actuation devices
13.24. Check of functioning of the switch
13.25. Dismantle and installation of the combined device
13.26. Not always simply to follow – "twisting" roads of wires
13.27. Protection against overloads – safety locks in salon and a motor compartment
13.28. It is carried out quickly – replacement of safety locks
13.29. Distributes strong working currents – the switching relay
13.30. An apportion of safety locks and the relay
14. Electroschemes
15. Car salon
16. A body
17. Technical characteristics
18. The help at malfunctions
 



ba88fb63



13-14-zamena-remennogo-prizhimnogo-rolika.html

13.14. Replacement of a belt clamping roller

Carburettor engines

 PERFORMANCE ORDER

    Remove приводной a belt as it is described above and... ... Then unscrew fixing nuts (are specified by arrows) on a clamping roller.

    Unscrew fixing nuts (are specified by arrows) on a clamping roller.

    Remove clamping a roller and... ... Put a new roller on a flange and slightly tighten screws. With the help динамометрического a key tighten then screws in a crosswise order the moment of an inhaling 25 Н·м. Finish installation upside-down.

Diesel engines

Engines DuraTorg-DI have two-section ременный a drive: one belt results, proceeding from a cranked shaft, through two rotary rollers the generator and the Expert-compressor. Other, shorter belt starts a camshaft through clamping a roller and ременный a pulley the pump of the steering mechanism with the amplifier.


«The previous page
13.13. Replacement приводных belts
The following page»
13.15. Dismantle and generator installation