Ford Mondeo since 2000
1. Introduction
2. Equipment
3. Care of the car
4. Engines
5. Greasing system
6. Cooling system
7. System of injection of fuel
8. Ignition system
9. Fuel system
10. Transmission
11. A running gear
12. Brake system
13. The electrotechnical equipment
13.1. The storage battery and a starter
13.2. The generator
13.3. Check of level of electrolit in the accumulator
13.4. Care of contacts
13.5. Check of the storage battery
13.6. Engine start "from outside" – with a wire connecting a starter and the auxiliary storage battery, without problems
13.7. Car pushing
13.8. Car towage
13.9. Gymnastics of the storage battery
13.10. Replacement of the storage battery
13.11. Revealing of secret consumers of the electric power
13.12. Check of a regulator of pressure
13.13. Replacement приводных belts
13.14. Replacement of a belt clamping roller
13.15. Dismantle and generator installation
13.16. Starter replacement
13.17. External illumination
13.18. Any big problems – replacement of lamps накаливания
13.19. A provisional measure – adjustment of headlights «before a wall»
13.20. Signalling devices
13.21. Check of the switch of a signal of braking
13.22. Check of a sound signal
13.23. Tools and actuation devices
13.24. Check of functioning of the switch
13.25. Dismantle and installation of the combined device
13.26. Not always simply to follow – "twisting" roads of wires
13.27. Protection against overloads – safety locks in salon and a motor compartment
13.28. It is carried out quickly – replacement of safety locks
13.29. Distributes strong working currents – the switching relay
13.30. An apportion of safety locks and the relay
14. Electroschemes
15. Car salon
16. A body
17. Technical characteristics
18. The help at malfunctions
 



ba88fb63





13-28-vypolnyaetsya-bystro-zamena-predokhranitelejj.html

13.28. It is carried out quickly – replacement of safety locks

The majority of safety locks is in salon at the left under a steering wheel. Also some relays in the same place take places. Additional boxes with safety locks and the relay can be found in a motor compartment at the left concerning a direction of movement behind a ledge of an amortisation rack. Before replacing a separate safety lock or the relay, it is desirable to disconnect ignition and all токопотребители (for example, a radio receiver).

 PERFORMANCE ORDER

    Pull out cautiously fused safety lock from a nest by means of a special clip (is on a cover of a box with safety locks in a motor compartment) or small flat-nose pliers. Track that the new safety lock had the same value in amperes, as its predecessor. Press both flat connectors simultaneously in штекерные ledges. If you do not wish to "fuse" there and then a new safety lock check up, whether the electric chain has connection to weight (the consumer defective, wire isolation was wiped through from weight).

«The previous page
13.27. Protection against overloads – safety locks in salon and a motor compartment
The following page»
13.29. Distributes strong working currents – the switching relay