Ford Mondeo since 2000
1. Introduction
2. Equipment
3. Care of the car
4. Engines
5. Greasing system
6. Cooling system
7. System of injection of fuel
8. Ignition system
9. Fuel system
10. Transmission
11. A running gear
12. Brake system
13. The electrotechnical equipment
13.1. The storage battery and a starter
13.2. The generator
13.3. Check of level of electrolit in the accumulator
13.4. Care of contacts
13.5. Check of the storage battery
13.6. Engine start "from outside" – with a wire connecting a starter and the auxiliary storage battery, without problems
13.7. Car pushing
13.8. Car towage
13.9. Gymnastics of the storage battery
13.10. Replacement of the storage battery
13.11. Revealing of secret consumers of the electric power
13.12. Check of a regulator of pressure
13.13. Replacement приводных belts
13.14. Replacement of a belt clamping roller
13.15. Dismantle and generator installation
13.16. Starter replacement
13.17. External illumination
13.18. Any big problems – replacement of lamps накаливания
13.19. A provisional measure – adjustment of headlights «before a wall»
13.20. Signalling devices
13.21. Check of the switch of a signal of braking
13.22. Check of a sound signal
13.23. Tools and actuation devices
13.24. Check of functioning of the switch
13.25. Dismantle and installation of the combined device
13.26. Not always simply to follow – "twisting" roads of wires
13.27. Protection against overloads – safety locks in salon and a motor compartment
13.28. It is carried out quickly – replacement of safety locks
13.29. Distributes strong working currents – the switching relay
13.30. An apportion of safety locks and the relay
14. Electroschemes
15. Car salon
16. A body
17. Technical characteristics
18. The help at malfunctions
 



ba88fb63





13-15-demontazh-i-montazh-generatora.html

13.15. Dismantle and generator installation

 PERFORMANCE ORDER

    Lift the top facing of the engine from the adjusting pins and disconnect then an earthing wire of the accumulator (on weight). Raise and reliably fix a forward part of the car. Dismantle – depending on type – приводной a belt. Remove then protective a casing of a wire from the generator and... ... "Release" it from all wire sockets and wires. Further unscrew fixing screws and pull out the generator from below from a motor compartment. Instal upside-down. Twirl fixing screws the moment 45 Н·м and wire ledges 8 Н·м. Do not forget to level in diesel variants the bottom facing of a motor compartment at it ненапряженном and then to fix as it should be from the middle outside.

«The previous page
13.14. Replacement of a belt clamping roller
The following page»
13.16. Starter replacement