> Check of the door contact switch. Ford Mondeo (since 2000 of release)
Ford Mondeo since 2000
1. Introduction
2. Equipment
3. Care of the car
4. Engines
5. Greasing system
6. Cooling system
7. System of injection of fuel
8. Ignition system
9. Fuel system
10. Transmission
11. A running gear
12. Brake system
13. The electrotechnical equipment
14. Electroschemes
15. Car salon
15.1. Ventilation and heating
15.2. From time to time to inspect heating and ventilation systems
15.3. Dismantle of the block of management by heating and ventilation
15.4. The fan
15.5. Search of malfunctions of the fan
15.6. Replacement of the engine of the fan
15.7. Replacement of lamps of salon
15.8. The switch
15.9. Coding ключазажигания
15.10. Check of the door contact switch
15.11. Radio receiver dismantle
15.12. Dismantle dynamics
15.13. Dismantle of the external aerial
15.14. It is not recommended – to dismantle forward seats independently
15.15. Dismantle of a back of back seats
15.16. Dismantle of an upholstery of a door in front
15.17. Dismantle of lateral glasses / стеклоподъемника
15.18. Стеклоподъемник
15.19. Engine adjustment стеклоподъемника
15.20. Dismantle of the door handle
15.21. Dismantle of the lock of a steering
16. A body
17. Technical characteristics
18. The help at malfunctions
 






ba88fb63

15-10-proverka-dvernogo-kontaktnogo-vyklyuchatelya.html

15.10. Check of the door contact switch

Door contact switches for internal illumination take places in door clamps of average and back racks. At occurrence of failures in their functioning check up the switch.

 PERFORMANCE ORDER

  1. Check up by means of a control lamp or a multimeter pressure on door contact switches.
  2. If pressure is not enclosed to them, check up in the beginning a safety lock.
  3. If the safety lock is perfectly in order, check up, beginning from the block of the safety locks, the wires laid to a door.
  4. Probably, on road will be found out breakage of a wire or free штекерный contact. Check up also the switch – often contacts can be clamped or корродирован a wire conclusion.
  5. Eliminate defect and then do not forget all switch with effort to move on sliding surfaces there-here and to grease with silicone oil.
  6. If the switch is strongly clamped, clean sliding surfaces gasoline for washing and slightly grease contacts.
  7. If also it does not lead to success replace the defective switch.

    Two in one: a door clamp with the door contact switch.


The previous page
15.9. Coding ключазажигания
The following page
15.11. Radio receiver dismantle