> Coding ключазажигания. Ford Mondeo (since 2000 of release)
Ford Mondeo since 2000
1. Introduction
2. Equipment
3. Care of the car
4. Engines
5. Greasing system
6. Cooling system
7. System of injection of fuel
8. Ignition system
9. Fuel system
10. Transmission
11. A running gear
12. Brake system
13. The electrotechnical equipment
14. Electroschemes
15. Car salon
15.1. Ventilation and heating
15.2. From time to time to inspect heating and ventilation systems
15.3. Dismantle of the block of management by heating and ventilation
15.4. The fan
15.5. Search of malfunctions of the fan
15.6. Replacement of the engine of the fan
15.7. Replacement of lamps of salon
15.8. The switch
15.9. Coding ключазажигания
15.10. Check of the door contact switch
15.11. Radio receiver dismantle
15.12. Dismantle dynamics
15.13. Dismantle of the external aerial
15.14. It is not recommended – to dismantle forward seats independently
15.15. Dismantle of a back of back seats
15.16. Dismantle of an upholstery of a door in front
15.17. Dismantle of lateral glasses / стеклоподъемника
15.18. Стеклоподъемник
15.19. Engine adjustment стеклоподъемника
15.20. Dismantle of the door handle
15.21. Dismantle of the lock of a steering
16. A body
17. Technical characteristics
18. The help at malfunctions



15.9. Coding ключазажигания

By means of a master key it is possible to code a spare key or a maximum eight twirls. The system does not demand maintenance service.

Spend the stages of coding listed more low within five seconds:


  1. Turn at first by means of a master key the ignition lock-switch in position II and …
  2. … then turn a master key back in a position 0. Now pull out a master key from the ignition lock-switch.
  3. Insert the second key into the lock-switch of ignition and turn it in position II.
  4. Turn the second key back in a position 0 and pull out it. The coding mode thus becomes more active. With an interval in ten seconds it is possible to repeat this process with the following not coded key.
  5. "Allow" again coded keys to remain in rest about five seconds – so much time is necessary for system for key activization.
  6. If coding process has been interrupted, the control lamp over hours starts to blink. In this case wait about 20 seconds and repeat process.
  7. In workshop Ford it is possible to spend replacement of a master key or to "erase" codes from already coded keys.

    Ignition key coding

The previous page
15.8. The switch
The following page
15.10. Check of the door contact switch