Ford Mondeo since 2000
1. Introduction
2. Equipment
3. Care of the car
4. Engines
5. Greasing system
6. Cooling system
7. System of injection of fuel
8. Ignition system
9. Fuel system
10. Transmission
11. A running gear
12. Brake system
13. The electrotechnical equipment
14. Electroschemes
15. Car salon
15.1. Ventilation and heating
15.2. From time to time to inspect heating and ventilation systems
15.3. Dismantle of the block of management by heating and ventilation
15.4. The fan
15.5. Search of malfunctions of the fan
15.6. Replacement of the engine of the fan
15.7. Replacement of lamps of salon
15.8. The switch
15.9. Coding ключазажигания
15.10. Check of the door contact switch
15.11. Radio receiver dismantle
15.12. Dismantle dynamics
15.13. Dismantle of the external aerial
15.14. It is not recommended – to dismantle forward seats independently
15.15. Dismantle of a back of back seats
15.16. Dismantle of an upholstery of a door in front
15.17. Dismantle of lateral glasses / стеклоподъемника
15.18. Стеклоподъемник
15.19. Engine adjustment стеклоподъемника
15.20. Dismantle of the door handle
15.21. Dismantle of the lock of a steering
16. A body
17. Technical characteristics
18. The help at malfunctions
 



ba88fb63





15-11-demontazh-radiopriemnika.html

15.11. Radio receiver dismantle

In the subsequent description only the attention is paid to serial complete set Ford. For additional installation of other radio components it is necessary to have co-ordinated with yours Mondeo completing set – the problems connected with their fastening and installation, thereby are excluded. The detailed instruction on installation is applied on a completing set.

 PERFORMANCE ORDER

    Write down before демонтажем in the presence of radio system with its antijoy ride device кодировочный number (a key code). Switch off ignition and disconnect the storage battery. Remove from protection the radio cassette device only by means of special U-shaped wire corners. For this purpose from each party insert into corresponding apertures on one corner. In regular intervals wring out corners outside (it allows to unblock fixing pads) and pull out the device on corners from an assembly niche. It allows to avoid damages to device fastening.

    Insert into apertures corners, wring out outside and then pull out with the device from an assembly niche.

    Mark conclusions to the back party of the device and after that pull out an antenna wire, токонесущий a wire, штекерное connection динамиков and connection on weight from corresponding nests. Spend work on installation upside-down.

    Mark conclusions and pull out them from corresponding nests.


«The previous page
15.10. Check of the door contact switch
The following page»
15.12. Dismantle dynamics