Ford Mondeo since 2000
1. Introduction
2. Equipment
3. Care of the car
4. Engines
5. Greasing system
6. Cooling system
7. System of injection of fuel
8. Ignition system
9. Fuel system
10. Transmission
11. A running gear
12. Brake system
13. The electrotechnical equipment
14. Electroschemes
15. Car salon
15.1. Ventilation and heating
15.2. From time to time to inspect heating and ventilation systems
15.3. Dismantle of the block of management by heating and ventilation
15.4. The fan
15.5. Search of malfunctions of the fan
15.6. Replacement of the engine of the fan
15.7. Replacement of lamps of salon
15.8. The switch
15.9. Coding ключазажигания
15.10. Check of the door contact switch
15.11. Radio receiver dismantle
15.12. Dismantle dynamics
15.13. Dismantle of the external aerial
15.14. It is not recommended – to dismantle forward seats independently
15.15. Dismantle of a back of back seats
15.16. Dismantle of an upholstery of a door in front
15.17. Dismantle of lateral glasses / стеклоподъемника
15.18. Стеклоподъемник
15.19. Engine adjustment стеклоподъемника
15.20. Dismantle of the door handle
15.21. Dismantle of the lock of a steering
16. A body
17. Technical characteristics
18. The help at malfunctions
 



ba88fb63



15-16-demontazh-obivki-dveri-speredi.html

15.16. Dismantle of an upholstery of a door in front

 PERFORMANCE ORDER

    Disconnect the storage battery and remove then internal facing of an external rear-view mirror. Pull out in the beginning заглушку 1, and then unscrew the screw 2.

    Remove internal facing of an external rear-view mirror. 1 заглушка, 2 screw.

    Disconnect the tip of the mechanism of a mirror and remove facing of an external mirror from a disk frame. Dismantle a diaphragm of the door handle. For this purpose in the beginning remove заглушку and then unscrew the screw located behind it. Dismantle facing of the door handle and … … unscrew both screws located behind it from a door. Remove door facing for what unscrew all screws (are specified by arrows).

    Remove door facing вывинчиванием all screws (arrow).

    Disconnect the tip electric стеклоподъемника and remove facing from a door. If now for penetration into inside doors, you need to remove a transparent film whenever possible do not catch at contact edges and gluing surfaces: after that the film can not be pasted again densely enough and rain water can get in a door. Finish work upside-down and track that the film everywhere has been along the edges tense densely. If is not present, put a silicone layer to a gluing surface.

«The previous page
15.15. Dismantle of a back of back seats
The following page»
15.17. Dismantle of lateral glasses / стеклоподъемника