Ford Mondeo since 2000
1. Introduction
2. Equipment
3. Care of the car
4. Engines
5. Greasing system
6. Cooling system
7. System of injection of fuel
8. Ignition system
9. Fuel system
10. Transmission
11. A running gear
12. Brake system
13. The electrotechnical equipment
14. Electroschemes
15. Car salon
15.1. Ventilation and heating
15.2. From time to time to inspect heating and ventilation systems
15.3. Dismantle of the block of management by heating and ventilation
15.4. The fan
15.5. Search of malfunctions of the fan
15.6. Replacement of the engine of the fan
15.7. Replacement of lamps of salon
15.8. The switch
15.9. Coding ключазажигания
15.10. Check of the door contact switch
15.11. Radio receiver dismantle
15.12. Dismantle dynamics
15.13. Dismantle of the external aerial
15.14. It is not recommended – to dismantle forward seats independently
15.15. Dismantle of a back of back seats
15.16. Dismantle of an upholstery of a door in front
15.17. Dismantle of lateral glasses / стеклоподъемника
15.18. Стеклоподъемник
15.19. Engine adjustment стеклоподъемника
15.20. Dismantle of the door handle
15.21. Dismantle of the lock of a steering
16. A body
17. Technical characteristics
18. The help at malfunctions
 



ein ba88fb63





15-7-zamena-lamp-salona.html

15.7. Replacement of lamps of salon

(For a separate lantern)

 PERFORMANCE ORDER

    Switch off salon illumination. Wring out a lantern a flat screw-driver on the party opposite to the switch (it is shown by an arrow), and …

    Wring out a lantern a flat screw-driver on the party and replace a lamp.

    … "unblock" a reflector. At once replace forward софитную a lamp (it is specified by an arrow), for replacement of a back lamp it is necessary to "unblock" in the beginning sideways one more reflector. To reach a glass socle lamp behind a sun-protection peak, at first cautiously wring out lamp glass шлицевой a screw-driver.

Fixtures for reading

 PERFORMANCE ORDER

    Dismantle the case of a lamp by means of a flat screw-driver and unbend lateral contact uvulas (are specified by arrows) from a lamp. Insert a new lamp and finish work upside-down.

    Dismantle the case of a lamp by means of a flat screw-driver and unbend lateral contact uvulas (arrows).

Lantern of a ware box

    Pull out an old lamp from a cartridge and insert into it a new lamp.

Lanterns of entrance doors

    Pull out an old lamp from a cartridge and insert into it a new lamp.

Luggage carrier lantern

    Cautiously wring out the case of a lamp by means of a flat screw-driver from an assembly aperture. Now it is possible to pull out софитную a lamp.

Dismantle the case of a lamp and pull out софитную a lamp.


«The previous page
15.6. Replacement of the engine of the fan
The following page»
15.8. The switch