Ford Mondeo since 2000
1. Introduction
2. Equipment
3. Care of the car
4. Engines
5. Greasing system
6. Cooling system
7. System of injection of fuel
8. Ignition system
9. Fuel system
10. Transmission
11. A running gear
12. Brake system
13. The electrotechnical equipment
14. Electroschemes
15. Car salon
15.1. Ventilation and heating
15.2. From time to time to inspect heating and ventilation systems
15.3. Dismantle of the block of management by heating and ventilation
15.4. The fan
15.5. Search of malfunctions of the fan
15.6. Replacement of the engine of the fan
15.7. Replacement of lamps of salon
15.8. The switch
15.9. Coding ключазажигания
15.10. Check of the door contact switch
15.11. Radio receiver dismantle
15.12. Dismantle dynamics
15.13. Dismantle of the external aerial
15.14. It is not recommended – to dismantle forward seats independently
15.15. Dismantle of a back of back seats
15.16. Dismantle of an upholstery of a door in front
15.17. Dismantle of lateral glasses / стеклоподъемника
15.18. Стеклоподъемник
15.19. Engine adjustment стеклоподъемника
15.20. Dismantle of the door handle
15.21. Dismantle of the lock of a steering
16. A body
17. Technical characteristics
18. The help at malfunctions
 



ba88fb63





15-17-demontazh-bokovykh-stekol-steklopodemnika.html

15.17. Dismantle of lateral glasses / стеклоподъемника

Lateral glass

 PERFORMANCE ORDER

    Align lateral glass by means of the tightening screw in a service aperture. For this purpose lower glass on approximately 160 mm.

    Align lateral glass by means of the tightening screw and lower it on approximately 160 mm.

    Dismantle, as it is described above, door facing. Dismantle, as it is described above, door динамик. Remove a tight film from a door. For this purpose disconnect gluing surface whenever possible a plastic knife. Try not to concern with her hands, differently the gluing effect can be gone. Unscrew tightening screws (are specified by arrows) in service apertures and …

    Unscrew tightening screws (are specified by arrows) in service apertures.

    … also remove a rubber lining (it is specified by an arrow) from a door. Now you had a place for вытаскивания from a door outside of a part of glass 1. For this purpose incline glass forward 2 and pull out it from a door.

    Incline glass forward 2 and wring out outside 1.

    At installation track that glass was inserted into a door outside. Instal upside-down.

«The previous page
15.16. Dismantle of an upholstery of a door in front
The following page»
15.18. Стеклоподъемник