Ford Mondeo since 2000
1. Introduction
2. Equipment
3. Care of the car
4. Engines
5. Greasing system
6. Cooling system
7. System of injection of fuel
8. Ignition system
9. Fuel system
10. Transmission
11. A running gear
12. Brake system
13. The electrotechnical equipment
14. Electroschemes
15. Car salon
15.1. Ventilation and heating
15.2. From time to time to inspect heating and ventilation systems
15.3. Dismantle of the block of management by heating and ventilation
15.4. The fan
15.5. Search of malfunctions of the fan
15.6. Replacement of the engine of the fan
15.7. Replacement of lamps of salon
15.8. The switch
15.9. Coding ключазажигания
15.10. Check of the door contact switch
15.11. Radio receiver dismantle
15.12. Dismantle dynamics
15.13. Dismantle of the external aerial
15.14. It is not recommended – to dismantle forward seats independently
15.15. Dismantle of a back of back seats
15.16. Dismantle of an upholstery of a door in front
15.17. Dismantle of lateral glasses / стеклоподъемника
15.18. Стеклоподъемник
15.19. Engine adjustment стеклоподъемника
15.20. Dismantle of the door handle
15.21. Dismantle of the lock of a steering
16. A body
17. Technical characteristics
18. The help at malfunctions



15.14. It is not recommended – to dismantle forward seats independently

The driver and the next passenger in Mondeo sit on so-called seats of type «Anti-Dive». The furniture of seats represents built in compound to a component of "comfortable" system of safety (IPS) Ford: their consoles are equipped pyrotechnic преднатяжителями belts which during failure instantly pull seat belts and by that to a minimum lower their degree leaky прилегания. At inadequate dismantle of seats преднатяжитель can "ignite and become unsuitable. If you all the same have dared at independent dismantle receive the corresponding information at the dealer Ford about necessary instructions on safety.

Reduces leaky прилегание: pyrotechnic преднатяжитель a seat belt on forward seats.

1 — the Lock of a seat belt with the gauge,
2 — Pyrotechnic натяжитель a seat belt,
3 — the Working case,
4 — Gazogenerator,
5 — the Block of ignition,
6 — the Rotary element,
7 — the Cable натяжителя.

 That the system of packing and a tension of seat belts could not work unintentionally, allow an occasion to unload to "current pressure»: after a detachment of the storage battery wait about one minute before pulling out the tip of system of packing and a tension of seat belts. The pillow of safety and pyrotechnic преднатяжитель otherwise will work. And as consequence – reception of traumas besides large expenses on the new system complete set.

Forward seat


    Disconnect the storage battery and after that wait about one minute. Completely overturn a seat back and … … pull out the basic tip натяжителя seat belts, the gauge of loading of a seat and – if it is established – the videosystem tip (it is specified by an arrow).

    Pull out the basic tip преднатяжителя seat belts.

    Unscrew forward screws and … … completely displace a seat forward. Dismantle from below seats belt fastening.

    Dismantle from below seats of fastening of a belt (at installation to tighten with the moment 38 Н·м).

    Unscrew both back facings from tyres and … … unscrew back screws of seats. Then pull out a seat from salon. Instal upside-down and tighten screws of a seat the moment 25 Н·м.

«The previous page
15.13. Dismantle of the external aerial
The following page»
15.15. Dismantle of a back of back seats