> Dismantle of the block of management by heating and ventilation. Ford Mondeo (since 2000 of release)
Ford Mondeo since 2000
1. Introduction
2. Equipment
3. Care of the car
4. Engines
5. Greasing system
6. Cooling system
7. System of injection of fuel
8. Ignition system
9. Fuel system
10. Transmission
11. A running gear
12. Brake system
13. The electrotechnical equipment
14. Electroschemes
15. Car salon
15.1. Ventilation and heating
15.2. From time to time to inspect heating and ventilation systems
15.3. Dismantle of the block of management by heating and ventilation
15.4. The fan
15.5. Search of malfunctions of the fan
15.6. Replacement of the engine of the fan
15.7. Replacement of lamps of salon
15.8. The switch
15.9. Coding ключазажигания
15.10. Check of the door contact switch
15.11. Radio receiver dismantle
15.12. Dismantle dynamics
15.13. Dismantle of the external aerial
15.14. It is not recommended – to dismantle forward seats independently
15.15. Dismantle of a back of back seats
15.16. Dismantle of an upholstery of a door in front
15.17. Dismantle of lateral glasses / стеклоподъемника
15.18. Стеклоподъемник
15.19. Engine adjustment стеклоподъемника
15.20. Dismantle of the door handle
15.21. Dismantle of the lock of a steering
16. A body
17. Technical characteristics
18. The help at malfunctions
 






ba88fb63

15-3-demontazh-bloka-upravleniya-otopleniem-i-ventilyaciejj.html

15.3. Dismantle of the block of management by heating and ventilation

As in practice presence of systems with manual regulation of temperature in salon the description of dismantle of the block of management for similar systems is more low resulted prevails.

 PERFORMANCE ORDER

  1. Disconnect the storage battery and dismantle a radio receiver or an audiosystem.
  2. Unscrew average screws from protective facing and …
  3. … cautiously pull out a switch cover (it is specified by an arrow) from the average console.

    Pull out a cover of the switch (arrow) from the average console.

  4. Further unscrew the bottom screws (are specified by arrows) from protective facing and pull out a decorative cover from the console so that the cable socket has not appeared too tense.

    Unscrew the bottom screws (arrows) from protective facing.

  5. Before pulling out the switch from a decorative cover, insert in the beginning a rag piece between a screw-driver and a cover. Then wring out the switch and disconnect a multicontact socket.

    Insert a rag piece between a screw-driver and a cover and only after that wring out the switch.

  6. Now unscrew the top screws (are specified by arrows) from protective facing and …

    Unscrew the top screws (arrows) from protective facing.

  7. … disconnect the tip (it is specified by an arrow) from the block of management of a heater/conditioner.

    Disconnect the tip (arrows) from the management block.

  8. Further unscrew four screws (are specified by arrows) and pull out the block of management from a niche.

    Unscrew screws (arrows) and pull out the block of management from a niche.

  9. Instal upside-down.

The previous page
15.2. From time to time to inspect heating and ventilation systems
The following page
15.4. The fan