> Dismantle of the external aerial. Ford Mondeo (since 2000 of release)
Ford Mondeo since 2000
1. Introduction
2. Equipment
3. Care of the car
4. Engines
5. Greasing system
6. Cooling system
7. System of injection of fuel
8. Ignition system
9. Fuel system
10. Transmission
11. A running gear
12. Brake system
13. The electrotechnical equipment
14. Electroschemes
15. Car salon
15.1. Ventilation and heating
15.2. From time to time to inspect heating and ventilation systems
15.3. Dismantle of the block of management by heating and ventilation
15.4. The fan
15.5. Search of malfunctions of the fan
15.6. Replacement of the engine of the fan
15.7. Replacement of lamps of salon
15.8. The switch
15.9. Coding ключазажигания
15.10. Check of the door contact switch
15.11. Radio receiver dismantle
15.12. Dismantle dynamics
15.13. Dismantle of the external aerial
15.14. It is not recommended – to dismantle forward seats independently
15.15. Dismantle of a back of back seats
15.16. Dismantle of an upholstery of a door in front
15.17. Dismantle of lateral glasses / стеклоподъемника
15.18. Стеклоподъемник
15.19. Engine adjustment стеклоподъемника
15.20. Dismantle of the door handle
15.21. Dismantle of the lock of a steering
16. A body
17. Technical characteristics
18. The help at malfunctions



15.13. Dismantle of the external aerial

The radio receiver established at factory for reception of radio signals uses the external aerial. External aerials are strongly enough fixed – provided that at passage of washing stations they preliminary are unscrewed from an antenna leg. Otherwise washing brushes get confused in a core of the aerial and can crack it. You can minimise appropriate expenses accordingly: get the suitable aerial in autoshop and by that will save expenses on installation at the expense of own purse. If it is necessary for you to spend new installation it is necessary also to "hide" in addition an antenna wire in a niche of a forward rack and a forward edge of an upholstery of a roof.

Antenna leg


  1. Disconnect the storage battery.
  2. Dismantle, as it is described above, internal illumination and disconnect the tip.
  3. Now unscrew from below the fixing screw on an old antenna leg (it is specified by an arrow) and …

    Unscrew the fixing screw of an antenna leg (arrow).

  4. ... Remove an antenna leg from a roof.
  5. For installation level a new leg on a roof (for this purpose temporarily screw the aerial) and hardly tighten it from within.
  6. Instal upside-down.

Antenna cable


  1. Mount – as it is described above – an aerial leg on a roof.
  2. Dismantle a covering of a forward rack, remove a sun-protection peak and it is very cautious a forward edge of an upholstery of a roof. Track a fixing tape on a forward rack (it is specified by an arrow) – before covering dismantle it is necessary to disconnect a tape from a forward rack.

    Disconnect a fixing tape from a covering of a forward rack.

  3. Release an antenna cable and …
  4. … dismantle a radio receiver.
  5. "Release" now a cable of the aerial from all fixing clips and pull out it from the radio tip.

    Release a cable of the aerial from all fixing clips

  6. Lay a new cable in the beginning without knock and then strongly clamp.
  7. Connect a cable to a radio receiver and an antenna leg.
  8. Finish work upside-down.

The previous page
15.12. Dismantle dynamics
The following page
15.14. It is not recommended – to dismantle forward seats independently