> Nozzle installation стеклоомывателя. Ford Mondeo (since 2000 of release)
Ford Mondeo since 2000
1. Introduction
2. Equipment
3. Care of the car
3.1. Internal clearing – at a dirt is not present any chances
3.2. An external sink
3.3. An engine sink
3.4. That all remains in movement, address in greasing service
3.5. Wish to keep material assets – look after colouring
3.6. Care of varnishing
3.7. Decrease in value of the goods – ugly defects of colouring
3.8. Elimination of defects from blows of stones
3.9. Polishing of small scratches
3.10. Elimination of large scratches
3.11. Installation for a sink of glasses
3.12. Check of a screen wiper and стеклоомывателя
3.13. Water pouring in стеклоомыватель
3.14. Replacement of rubber of a brush of a screen wiper
3.15. Nozzle installation стеклоомывателя
3.16. Installation and nozzle dismantle стеклоомывателя
3.17. Dismantle and installation of the lever of a screen wiper
3.18. Dismantle and installation of the electric motor of a forward screen wiper
3.19. Dismantle and installation of the electric motor of a back screen wiper
4. Engines
5. Greasing system
6. Cooling system
7. System of injection of fuel
8. Ignition system
9. Fuel system
10. Transmission
11. A running gear
12. Brake system
13. The electrotechnical equipment
14. Electroschemes
15. Car salon
16. A body
17. Technical characteristics
18. The help at malfunctions
 






ba88fb63

3-15-ustanovka-sopla-stekloomyvatelya.html

3.15. Nozzle installation стеклоомывателя

Depending on a complete set you Mondeo can have warmed nozzles on an engine cowl. For increase in their clearing ability of a nozzle it is necessary to establish by means of a needle or a writing paper clip strictly in a certain point of glass.

 PERFORMANCE ORDER

  1. To turn apertures snuffled by means of a needle or a writing paper clip, in the beginning cautiously "pierce" an aperture of a nozzle the needle or wire end and turn a nozzle in the best position of injection.
  2. That at the small expense of water to reach the good clearing result, direct nozzles approximately on the top third of zone of washing.

    Correctly established nozzles стеклоомывателей should inject water on glass into a zone of the sizes specified in drawing.

    And = 140 – 240 mm
    In = 190 – 290 mm
    With = 270 – 370 mm


The previous page
3.14. Replacement of rubber of a brush of a screen wiper
The following page
3.16. Installation and nozzle dismantle стеклоомывателя