> Installation and nozzle dismantle стеклоомывателя. Ford Mondeo (since 2000 of release)
Ford Mondeo since 2000
1. Introduction
2. Equipment
3. Care of the car
3.1. Internal clearing – at a dirt is not present any chances
3.2. An external sink
3.3. An engine sink
3.4. That all remains in movement, address in greasing service
3.5. Wish to keep material assets – look after colouring
3.6. Care of varnishing
3.7. Decrease in value of the goods – ugly defects of colouring
3.8. Elimination of defects from blows of stones
3.9. Polishing of small scratches
3.10. Elimination of large scratches
3.11. Installation for a sink of glasses
3.12. Check of a screen wiper and стеклоомывателя
3.13. Water pouring in стеклоомыватель
3.14. Replacement of rubber of a brush of a screen wiper
3.15. Nozzle installation стеклоомывателя
3.16. Installation and nozzle dismantle стеклоомывателя
3.17. Dismantle and installation of the lever of a screen wiper
3.18. Dismantle and installation of the electric motor of a forward screen wiper
3.19. Dismantle and installation of the electric motor of a back screen wiper
4. Engines
5. Greasing system
6. Cooling system
7. System of injection of fuel
8. Ignition system
9. Fuel system
10. Transmission
11. A running gear
12. Brake system
13. The electrotechnical equipment
14. Electroschemes
15. Car salon
16. A body
17. Technical characteristics
18. The help at malfunctions
 






ba88fb63 Зеркало azartplay casino.

3-16-montazh-i-demontazh-sopla-stekloomyvatelya.html

3.16. Installation and nozzle dismantle стеклоомывателя

The corked nozzles стеклоомывателей it is necessary to dismantle and blow at once expediently in a direction of connection of a hose the compressed air. Persistent pollution cautiously to push a thin wire – also in a direction of connection of a hose. If it is not possible, replace a nozzle and insert if necessary at once the usual fuel filter into the pipeline submitting water. The melkoporistyj filter in the future will allow to remain for a long time to nozzles pure.

 PERFORMANCE ORDER

  1. Open a cowl of the engine and remove isolating material (clips wring out a screw-driver).
  2. Before removal of a water hose of a washer from a nozzle warm up it a little by means of a lighter.
  3. Compress fingers fixing uvulas, thus simultaneously wring out a nozzle from a cowl (if necessary take a nozzle by means of a screw-driver – thus protect varnishing by means of a substrate!). Disconnect from нагретого nozzles a connecting wire.
  4. At installation outside "fix" a nozzle in a cowl. Track that the nozzle sat strongly, otherwise there will be problems with its installation.
  5. Connect a water hose and an electric wire, adjust nozzle position as it is described above.
  6. Fix isolating material.

The previous page
3.15. Nozzle installation стеклоомывателя
The following page
3.17. Dismantle and installation of the lever of a screen wiper