Ford Mondeo since 2000
1. Introduction
2. Equipment
3. Care of the car
3.1. Internal clearing – at a dirt is not present any chances
3.2. An external sink
3.3. An engine sink
3.4. That all remains in movement, address in greasing service
3.5. Wish to keep material assets – look after colouring
3.6. Care of varnishing
3.7. Decrease in value of the goods – ugly defects of colouring
3.8. Elimination of defects from blows of stones
3.9. Polishing of small scratches
3.10. Elimination of large scratches
3.11. Installation for a sink of glasses
3.12. Check of a screen wiper and стеклоомывателя
3.13. Water pouring in стеклоомыватель
3.14. Replacement of rubber of a brush of a screen wiper
3.15. Nozzle installation стеклоомывателя
3.16. Installation and nozzle dismantle стеклоомывателя
3.17. Dismantle and installation of the lever of a screen wiper
3.18. Dismantle and installation of the electric motor of a forward screen wiper
3.19. Dismantle and installation of the electric motor of a back screen wiper
4. Engines
5. Greasing system
6. Cooling system
7. System of injection of fuel
8. Ignition system
9. Fuel system
10. Transmission
11. A running gear
12. Brake system
13. The electrotechnical equipment
14. Electroschemes
15. Car salon
16. A body
17. Technical characteristics
18. The help at malfunctions
 



ba88fb63



3-19-demontazh-i-montazh-ehlektrodvigatelya-zadnego-stekloochistitelya.html

3.19. Dismantle and installation of the electric motor of a back screen wiper

Dismantle

 PERFORMANCE ORDER

    Result the screen wiper engine in a parking starting position, disconnect a wire on weight of the accumulator and dismantle the lever of a back screen wiper. Open a back door and dismantle facing. Before dismantling the engine, disconnect the tip and wring out it. Disconnect a wire on weight... ... Unscrew three fixing screws (are specified by arrows) and pull out the engine from a door.

    Dismantle of facing of a back door

    Dismantle of facing of a back door (Turnie)

    Dismantle of the engine of a back screen wiper

Installation

 PERFORMANCE ORDER

    In the beginning screw the engine on an assembly plate the moment of an inhaling 7 Н·м. Check up, that the engine was in parking position, and... ... Close the engine. Finish installation upside-down and tighten the lever of a screen wiper the moment 14 Н·м. Check up functioning and if necessary again level screen wiper nozzles on glass.

«The previous page
3.18. Dismantle and installation of the electric motor of a forward screen wiper
The following page»
4. Engines