Ford Mondeo since 2000
1. Introduction
2. Equipment
3. Care of the car
3.1. Internal clearing – at a dirt is not present any chances
3.2. An external sink
3.3. An engine sink
3.4. That all remains in movement, address in greasing service
3.5. Wish to keep material assets – look after colouring
3.6. Care of varnishing
3.7. Decrease in value of the goods – ugly defects of colouring
3.8. Elimination of defects from blows of stones
3.9. Polishing of small scratches
3.10. Elimination of large scratches
3.11. Installation for a sink of glasses
3.12. Check of a screen wiper and стеклоомывателя
3.13. Water pouring in стеклоомыватель
3.14. Replacement of rubber of a brush of a screen wiper
3.15. Nozzle installation стеклоомывателя
3.16. Installation and nozzle dismantle стеклоомывателя
3.17. Dismantle and installation of the lever of a screen wiper
3.18. Dismantle and installation of the electric motor of a forward screen wiper
3.19. Dismantle and installation of the electric motor of a back screen wiper
4. Engines
5. Greasing system
6. Cooling system
7. System of injection of fuel
8. Ignition system
9. Fuel system
10. Transmission
11. A running gear
12. Brake system
13. The electrotechnical equipment
14. Electroschemes
15. Car salon
16. A body
17. Technical characteristics
18. The help at malfunctions
 



ba88fb63





3-8-ustranenie-defektov-ot-udarov-kamnejj.html

3.8. Elimination of defects from blows of stones

 PERFORMANCE ORDER

    Eliminate acting edges around лунки in varnishing by means of a thin needle or an hour screw-driver. Cautiously scratch out a rust a sharp knife. Then put a drop of the converter of corrosion in this place and allow it to work within approximately hour. Now clean a damage place varnish solvent and then thoroughly dry. Inject a little an aerosol first coat on a cover распылительного nozzles and put its thin brush or a finger-tip a thin layer to the place of damage. The first coat should dry out well. Press a finger-tip or a small plastic knife a little шпаклевки in лунку deterioration заподлицо with surrounding лакировочной a surface and allow to it to dry up. A stain шпаклевки on varnishing quickly wipe a rag. Cautiously grind weight шпаклевки narrow, fitted round the end of a pencil a strip of a thin grinding paper. Always rotate a pencil between palms Inject an integumentary varnish into a cover of a nozzle and allow to it to be aired within a minute. Then it is possible to put the condensed varnish a finger-tip or a sharp brush. Completely dried up varnish it is necessary further (in the summer about the ambassador of two, in the winter after about five days) extensively to polish полиролем or a varnish cleaner.

«The previous page
3.7. Decrease in value of the goods – ugly defects of colouring
The following page»
3.9. Polishing of small scratches