Ford Mondeo since 2000
1. Introduction
2. Equipment
3. Care of the car
4. Engines
5. Greasing system
6. Cooling system
7. System of injection of fuel
8. Ignition system
9. Fuel system
10. Transmission
11. A running gear
11.1. Forward bridge Mondeo
11.2. The service factor – geometry of the forward bridge
11.3. Check of shock-absorbers – is obligatory after deterioration of two complete sets of tyres
11.4. Regular check of a free wheeling of a steering wheel
11.5. Check of protective cuffs gear рейки
11.6. Check of tips of cross-section steering draught and cuffs
11.7. Check of the bearing of the cross-section lever of a suspension bracket
11.8. Check of a backlash of the wheel bearing
11.9. Replacement of the forward cross-section lever of a suspension bracket
11.10. Dismantle and installation of an amortisation rack
11.11. Replacement of tips of cross-section steering draught
11.12. Replacement of cuffs of the steering mechanism
11.13. Replacement of a rotary support of the steering mechanism
11.14. Dismantle and installation of a back amortisation rack
11.15. Replacement of the shock-absorber (versatile person)
11.16. The steering mechanism with the amplifier
11.17. Tyres and disks
11.18. It is better to check on cold tyres – pressure of air
11.19. Wheel replacement
11.20. Check of a condition of tyres
12. Brake system
13. The electrotechnical equipment
14. Electroschemes
15. Car salon
16. A body
17. Technical characteristics
18. The help at malfunctions
 



ba88fb63




11-10-demontazh-i-montazh-amortizacionnojj-stojjki.html

11.10. Dismantle and installation of an amortisation rack

 PERFORMANCE ORDER

    Out of the blue reliably put the car on goats and dismantle a corresponding forward wheel. On an amortisation rack release the holder of a brake hose and a connecting bar of the stabilizer. Dismantle скобу the disk brake mechanism together with a board of the brake mechanism (it is specified by arrows) from a rotary support and suspend their wire in a wheel niche.

    Dismantle скобы the disk brake mechanism.


    Mondeo with the diesel engine
    Dismantle facing of the engine and...

    All models
    ... A reflector from an auxiliary frame. Lower, as it is described above, the corresponding party of an auxiliary frame and dismantle the spherical hinge. Unscrew tightening the screw (it is specified by an arrow) from an amortisation rack.

    Unscrew tightening the screw from an amortisation rack.

    Prop up a power shaft. As much as possible admissible corner of bending of the internal hinge makes 18 ° and the external hinge, accordingly, 45 °. Separate a rotary fist from an amortisation rack and... ... Dismantle rack facing in a motor compartment. Dismantle an amortisation rack and thus ask the assistant to support it. Instal upside-down. For installation it is necessary, that the rack has been strictly aligned between ledges of an amortisation rack. Track that an arrow and a white line in the top part specified forward. Tighten against the stop the top screws only when the rotary support of the steering mechanism with an amortisation rack will be fixed in the assembly position. Spend a trial trip, then check up all screw connections and after that поезжайте with the Mondeo in each case on station of optical check and adjustment of geometry of the forward bridge.
«The previous page
11.9. Replacement of the forward cross-section lever of a suspension bracket		 The following page»
11.11. Replacement of tips of cross-section steering draught