Ford Mondeo since 2000
1. Introduction
2. Equipment
3. Care of the car
4. Engines
5. Greasing system
6. Cooling system
7. System of injection of fuel
8. Ignition system
9. Fuel system
10. Transmission
11. A running gear
11.1. Forward bridge Mondeo
11.2. The service factor – geometry of the forward bridge
11.3. Check of shock-absorbers – is obligatory after deterioration of two complete sets of tyres
11.4. Regular check of a free wheeling of a steering wheel
11.5. Check of protective cuffs gear рейки
11.6. Check of tips of cross-section steering draught and cuffs
11.7. Check of the bearing of the cross-section lever of a suspension bracket
11.8. Check of a backlash of the wheel bearing
11.9. Replacement of the forward cross-section lever of a suspension bracket
11.10. Dismantle and installation of an amortisation rack
11.11. Replacement of tips of cross-section steering draught
11.12. Replacement of cuffs of the steering mechanism
11.13. Replacement of a rotary support of the steering mechanism
11.14. Dismantle and installation of a back amortisation rack
11.15. Replacement of the shock-absorber (versatile person)
11.16. The steering mechanism with the amplifier
11.17. Tyres and disks
11.18. It is better to check on cold tyres – pressure of air
11.19. Wheel replacement
11.20. Check of a condition of tyres
12. Brake system
13. The electrotechnical equipment
14. Electroschemes
15. Car salon
16. A body
17. Technical characteristics
18. The help at malfunctions
 



ba88fb63 Новости о импортных сигаретах.




11-12-zamena-manzhet-rulevogo-mekhanizma.html

11.12. Replacement of cuffs of the steering mechanism

 PERFORMANCE ORDER

    Dismantle tips of cross-section steering draught as it is described above, and precisely count at вывинчивании number of coils of a carving (look section Replacement of tips of cross-section steering draught).

    Mondeo with the diesel engine
    Dismantle engine facing. At replacement of the left cuff in the beginning it is necessary to remove facing of a wheel niche.

    Dismantle of facing of a wheel niche.


    All models
    Unscrew a counternut of a trailer element of cross-section steering draught and clean draught. Pull out now a ventilating tube 1 of a rubber cuff and "crack" clamping strips 2.

    Pull out a ventilating tube and "crack" tightening collars.

    Depending on model instal upside-down. Do not forget to clean before installation and slightly to grease cross-section steering draught. Cautiously pull new cuffs on cross-section draught. Preliminary also slightly grease cuffs from both ends. Track that cuffs were not turned (connection of a ventilating tube specifies top) and correctly sat in grooves of cross-section steering draught, and also картера the steering mechanism. Otherwise oil can flow out or in due course the cuff will break. Fix cuffs new tightening collars and... ... Again spend measurements of geometry of the forward bridge.
The previous page
11.11. Replacement of tips of cross-section steering draught		 The following page
11.13. Replacement of a rotary support of the steering mechanism