|
11-11-zamena-nakonechnikov-poperechnojj-rulevojj-tyagi.html
11.11. Replacement of tips of cross-section steering draughtTips, accordingly at the left and on the right, are screwed on cross-section steering draught. Advantage: in the presence of defective tips it is not necessary to replace all cross-section steering draught.
|
|
Out of the blue reliably put the car on goats and dismantle a forward wheel.
Ослабьте in the beginning on the lever of a rotary fist самоконтрящуюся a nut of a tip of cross-section steering draught on some turns and...
... Wring out from the lever of a rotary fist a tip by means of a stripper for cams or spherical hinges. Completely unscrew a nut and pull out a tip from the lever of a rotary fist.
Further release a tightening nut on a tip and unscrew a trailer element from cross-section steering draught. However thus do not forget to count precisely at first "free" carving coils of a tip out of steering draught. Then establish a new tip with same "length" of installation. If all of you have strictly executed, it will allow to avoid the subsequent correction of a convergence of wheels.
|
|
A few "luck" will not prevent after replacement of a tip of cross-section steering draught. Before dismantle measure size «Х» and use it at installation of a new tip. If the car after repair does not conduct, it is possible to refuse measurements on geometry check. |
|
|
It is necessary to mount always tips of cross-section steering draught with new самоконтрящимися nuts. |
|
|
|
|
